1、 It can work without the need to connect the power supply to the air source.
2、 Sensor control does not require a foot switch for precise head stripping, ensuring safety and worry free.
3、 The peeling length, cutting depth, and half and full peeling are all adjusted by the scale knob without the need for tool assistance, which is simple and fast.
4、 Adopting a 90 degree V-shaped blade design with strong versatility, it is not necessary to replace the blade when machining different wires.
5、 Processing range AWG32-12 (0.03-4MM).
6、 The peeling length is 1mm to 20mm.
7、 Small size (2KG), easy to move, and can work normally in places with air sources.
1、 Application scope
It can process cables in a very short amount of time. And the universal blade system can significantly reduce the time required for tool replacement. The main characteristics of this machine are high precision, high efficiency, and fast investment return cycle.
The compact design allows multiple processing units to be integrated into one workstation. And when processing wire harnesses and multi-core cables, a compact design is also the most efficient way to process them.
Wire type
Discrete solid core wire, single stranded wire, single core cable, wire and cable, rubber wire, PUR PVC Teflon ®
2、 Technical parameters
Cable cross-section: 0.03-2.08 mm 2  (32-14 AWG)
Pneumatic wire stripping machine
Maximum cable outer diameter: 3.2 mm (0.12 ")
Peeling processing accuracy complete Peeling: 1 mm (0.019 ")
Partial peeling: 2 mm (0.078 ")
Diameter setting accuracy: 0.01 mm (0.001 ")
Peeling length: 1-20 mm
Processing time: approximately 0.3s per piece
Dimensions (L * W * H): 265 x 70 x 135 mm (10.4 "x 2.8" x 5.3 ")
Net weight: 2.0 kg (4.4 lbs.)
Gross weight: 2.4 kg (5.3 lbs.)
Air pressure: 0.5Pa-0.8Pa
Applicable line types: PVC, solid core wire, single stranded wire, single core cable, rubber wire, computer core wire, telephone wire and other thin wires.

Adjustable processing parameters
Knob 1 is the peeling length adjustment knob. Adjust the knob to the corresponding scale based on the actual peeling length. The knob only allows counterclockwise rotation
Knob 2 is used to adjust the stripping stroke, that is, half stripping or full stripping. Turning the stripping stroke clockwise reduces the stripping stroke to achieve half stripping, and turning it counterclockwise increases the stripping stroke to achieve full stripping
Knob 3 is used to adjust the depth of the peeling knife. When the diameter of the wire to be cut changes, the knife edge should be adjusted to a suitable depth to avoid damaging the core wire or preventing the insulation layer from peeling off. Rotate the knife edge clockwise to make the cutting depth shallower, and counterclockwise to make the knife edge deeper
4 is the main switch of the machine. Move the machine up to cut off all air sources, and move the machine down to introduce the air source to start wire processing